男澡堂洗澡勃起好大一根,少妇和公翁系列小说,色偷偷AV老熟女,亚洲国产精华液网站W

技術文章您現在的位置:首頁 > 技術文章 > ELISA操作指南
ELISA操作指南
更新時間:2013-01-09   點擊次數:1576次

 The following video tutorial described how to run a sandwich ELISA, also known as enzyme-linked immunosorbent assay, using a general PeproTech protocol.

       接下來的實驗指導講述PeproTech夾心法ELISA,即酶聯免疫吸附試驗的通用步驟

The capture, standard, and detection are supplied as stable lyophilized products, and should be stored at -20℃ until ready for use.
       捕獲抗體、標準品和檢測抗體均為凍干粉,使用前應保存于-20℃

Reconstituted Capture, Standard, and Detection components are only guaranteed to be stable for up to 2 weeks when stored at 4 ℃.
       捕獲抗體、標準品和檢測抗體重懸后,在4℃時zui長保存2周。

If you have reconstituted the EDK, and plan on using it for a duration greater than two weeks, aliquot and store at -20℃ for up to 6 months.
       如果您已重懸了EDK的各組份,并準備在2周之后使用,請將重懸的組分分裝并凍存于-20℃,zui長可保存6個月。

In contrast to the other three EDK components, the Avidin-HRP vial comes ready to use
       與EDK的其它三個組分不同,Avidin-HRP為即用型

In order to avoid harmful repeated freeze/thaw cycles, or long-term storage at 4 ℃ w

hich mean advisory functionality. Aliquot the Avidin-HRP into ten 6uL vials upon receipt and stored at -20 ℃ are stable for up 2 years from the date of receipt.
       目的是避免反復凍融或長期4℃保存對該組分的功能損害。收到Avidin-HRP后,立即將其分裝為6ul/管,共10管,凍存于-20℃,zui長可保存2年

Phase 1:
       第1階段:

Coating the plate with capture antibody
       捕獲抗體包板

Centrifuge the vial briefly to bring the capture antibody to the bottom
       將捕獲抗體稍作離心,使抗體集中于管底

Reconstitute the capture body in sterile water to the concentration specified on the datasheet. And allow the vial to be reconstituted for minimum 10 minutes.
       用無菌水將捕獲抗體重懸至說明書上要求的濃度,靜置10分鐘以使抗體*溶解

Centrifuge the reconstituted vial for 3 minutes at maximum speed
       重懸的抗體以zui高速度離心3分鐘

Dilute the capture antibody in 1×PBS to the concentration specified on the datasheet.
       用1xPBS稀釋捕獲抗體至說明書上要求的濃度

Gently mix or vortex the vial, try to ensure the air bubbles don’t mix into the solution,
       輕輕顛倒或振蕩混勻,一定不要產生氣泡

Immediay add 100ul of the capture antibody solution into the ELISA plate wells.
       立即在每個ELISA板孔中加入100uL捕獲抗體

Press firmly to seal the plate, take care not to let the reagent splash on the film
       將封板膜用力壓蓋在ELISA板上,注意不要使抗體滴濺在封板膜上

Incubated the plate overnight at 25 ℃, alternatively the incubation for this phase can be done at 37℃ for 2-4 hours
       25 ℃孵育過夜,或者37℃孵育2-4個小時

To wash the plate, discard the liquid and blot on a clean paper towel,
       洗板時需將液體倒掉,并在干凈的吸水紙上拍干

Add 300ul of the wash buffer to every well and then aspirate the plate
       每孔加入300ul 洗液,然后再將液體吸除

Repeat the step three additional times, totaling four washes in all.
       該步驟再重復3次,總共洗滌4次

After the last wash, invert the plate to move liquid, and blot on a clean paper towel.
       zui后一次洗滌后,將板倒置以去除液體,并在干凈的吸水紙上拍干

There are several other methods to wash an ELISA plate.Whatever you choose, be consistent with your washing technique throughout the whole process.
       ELISA板還有其它幾種洗滌方法。無論使用哪種方法,請在整個ELISA實驗過程中保持一致

Phase 2: Blocking non-specific binding
       第二階段:封閉非特異性結合

Bovine serum albumin is used as the blocking reagent to block any unbound open sites within the plastic wells
       牛血清白蛋白作為封閉試劑,可封閉塑料孔內任何未結合蛋白的位點

Add 300ul of the blocking buffer to each well.
       每孔中加入300ul封閉液

Seal the plate and incubate for at least 1 hour at 25 ℃.
       封板,并在25 ℃孵育至少1小時

詳細請看:ELISA操作指南

 

化工儀器網

推薦收藏該企業網站
公和我做爽死我死了A片在线| 全黄性性激高免费视频| 局长人妻互换不带套| 波多野结衣 电影| 日本乱偷互换人妻中文字幕| 粗大猛烈进出高潮视频免费看| 亚洲熟妇AV一区二区三区浪潮| 99久久99久久精品国产片| 色欲久久久天天天综合网精品| 巨粗进入警花哭喊求饶| 久久女婷五月综合色啪小说| 日本XXXX色视频在线观看| 长篇乱肉合集乱500小说| 亚洲精品乱码久久久久久按摩| 久久久久无码专区亚洲AV| 自拍偷自拍亚洲精品情侣| 亚洲和欧洲一码二码区别在| 亚洲AV综合永久无码精品天堂| 乳夹 震动 走绳play 调教| 麻豆精品久久久久久久99蜜桃| 女性扒开大腿露出私密部位| 97影院理论午夜伦不卡偷| 人人妻人人玩人人澡人人爽| 无码人妻一区二区三区| 人人妻人人澡人人爽人人精品电影| 精品国产乱码久久久久久1区2区| 伦人伦XXXX国语对白| 人人澡人人澡人人看添AV| 够力七星彩排列五奖表最新版本| CHINESE国产XXXX实拍| 久久国产精品无码一区二区三区| 亚洲熟妇无码另类久久久| 无遮挡边吃摸边吃奶边做| 偷妻之寂寞难耐2中文字幕| 无码任你躁久久久久久老妇APP| 少妇人妻人伦A片| 欧美被狂躁高潮A片视频| 精品人妻无码区二区三区| 国产色在线 | 日韩| 花蝴蝶日本视频中文| 性色欲网站人妻丰满中文久久不卡|